6. Your company has recently deployed a server that runs Windows Server 2008. The server has the IP
information shown below:
IP address: 192.168.46.186
Subnet mask: 255.255.255.192
Default gateway: 192.168.46.1
Users on remote subnets report that they are unable to connect to the server.
You need to ensure all users are able to connect to the server.
What should you do?
A. Change the IP address to 192.168.46.129.
B. Change the IP address to 192.168.46.200.
C. Change the subnet mask to a 24-bit mask.
D. Change the subnet mask to a 27-bit mask.
Answer: C
———————
7. You have a Windows Server 2008 computer that has an IP address of 172.16.45.9/21.
The server is configured to use IPv6 addressing.
You need to test IPv6 communication to a server that has an IP address of 172.16.40.18/21.
What should you do from a command prompt?
A. Type ping 172.16.45.9:::::.
B. Type ping ::9.45.16.172.
C. Type ping followed by the Link-local address of the server.
D. Type ping followed by the Site-local address of the server.
Answer: C
—————————–
8. You configure a new file server that runs Windows Server 2008. Users access shared files on the file server.
Users report that they are unable to access the shared files.
The TCP/IP properties for the file server are configured as shown in the following exhibit.
Pass4Side Microsoft 70-642
Pass4Side Help you pass any IT Exams! Page 5 of 10
You need to ensure that users are able to access the shared files.
How should you configure the TCP/IP properties on the file server?
A. Configure a static IP address.
B. Configure the default gateway.
C. Configure the DNS server address.
D. Add the domain to the DNS suffix on the network interface.
Answer: A
————————
9. Your company has a single Active Directory domain. The domain runs at the functional level of Windows
Server 2003.
You install the DHCP service on a server named DHCP1. You attempt to start the DHCP service, but it does not
start.
You need to ensure that the DHCP service starts.
What should you do?
A. Restart DHCP1.
B. Configure a scope on DHCP1.
C. Activate the scope on DHCP1.
D. Authorize DHCP1 in the Active Directory domain.
Answer: D
—————————-
10. Your company has an Active Directory forest. The corporate network uses DHCP to configure client computer
IP addresses.
The DHCP server has a DHCP client reservation for a portable computer named WKS1. You install a second
DHCP server on the network.
You need to ensure that WKS1 receives the DHCP reservation from the DHCP service.
What should you do?
A. Run the ipconfig /renew command on WKS1.
B. Run the netsh add helper command on WKS1.
C. Add the DHCP reservation for WKS1 to the second DHCP server.
D. Add both DHCP servers to the RAS and IAS Servers group in the Active Directory domain.
Answer: C
More Infomation Visit: